Moving Nozzle Controller


The Syncronorm MNC is intended to control single Moving Nozzles and 2D Fountain Nozzles. The Moving Nozzle Controller can be used in center sensor or in end sensor mode (separate selectable personalities). Fully DMX RDM compatible with Syncronorm hardware. All settings are set remotely via the Depence Software DMX RDM tool and are stored in non volatile Memory.

Key Features

DIN-Rail Mounting
Full RDM-Support
Sensor Connectivity
Dimensions160x90x58mm DIN Rail 6.5U
Protection ClassIP20
Power Supply24V DC
Operation Temperature0..40°C/0..80% humidity
Outputs4x Control Outputs 24V DC
2x Sensor Inputs
Order NumberSN-STMNCLR


* This unit requires the SyncroTools DMX address board (SN-STADRB)